LYCOS RETRIEVER 
Ethernet: Ethernet Address
built 631 days ago
The Ethernet address in which all the bits are 1 is known as a broadcast address. It is represented as FF:FF:FF:FF:FF:FF. A frame with this address is received and processed by all the nodes in the network.
Source:
Despite the physical star topology, hubbed Ethernet networks still use half-duplex and CSMA/CD, with only minimal activity by the hub, primarily the Collision Enforcement signal, in dealing with packet collisions. Every packet is sent to every port on the hub, so bandwidth and security problems aren't addressed. The total throughput of the hub is limited to that of a single link and all links must operate at the same speed.
Source:
In 1973, at Xerox Corporation’s Palo Alto Research Center (more commonly known as PARC), researcher Bob Metcalfe designed and tested the first Ethernet network. While working on a way to link Xerox’s "Alto" computer to a printer, Metcalfe developed the physical method of cabling that connected devices on the Ethernet as well as the standards that governed communication on the cable. Ethernet has since become the most popular and most widely deployed network technology in the world. Many of the issues involved with Ethernet are common to many network technologies, and understanding how Ethernet addressed these issues can provide a foundation that will improve your understanding of networking in general.
Source:
A limitation of 1,024 nodes (physical addresses) per network address exists on an Ethernet network. Addresses are assigned by IEEE to the vendor for the first three bytes of a six-byte address. The vendor is responsible for assigning the rest of the address and ensuring unique IDs. These unique addresses are called Burned-In Addresses (BIA).
Source:
The experimental Ethernet described in that paper ran at 3 Mbit/s, and had 8-bit destination and source address fields, so Ethernet addresses were not the global addresses they are today. By software convention, the 16 bits after the destination and source address fields were a packet type field, but, as the paper says, "different protocols use disjoint sets of packet types", so those were packet types within a given protocol, rather than the packet type in current Ethernet which specifies the protocol being used.
Source:
Data sent over the Ethernet exists in the forms of frames. An Ethernet frame contains a header, a data section, and a footer having a combined length of no more than 1518 bytes. The Ethernet header contains the addresses of both the intended recipient and the sender.
Source:
MORE ABOUT
Ethernet Address