LYCOS RETRIEVER 
Diode
built 656 days ago
Diode laser hair removal treatment essentially, works by using a tapered laser beam to burn and cauterize the problem hair follicles. It sounds very painful but in reality it is not. You can experience mild discomfort for a short time but a little discomfort now is surely worth a lifetime of smooth skin. The biggest advantage of diode laser hair removal is that there aren’t any side effects you will experience. Moreover, you can notice the change after your first session itself.
Source:
The Diode block models a piecewise linear diode. If the voltage across the diode is bigger than the Forward voltage parameter value, then the diode behaves like a linear resistor with low resistance, given by the On resistance parameter value, plus a series voltage source. If the voltage across the diode is less than the forward voltage, then the diode behaves like a linear resistor with low conductance given by the Off conductance parameter value.
Source:
Diode can be connected to a battery in two ways. First, anode of the diode to negative terminal of the battery and cathode to the positive terminal of the battery. Second method is to connect the anode of diode to the positive terminal of the battery and cathode to the negative terminal of the batterv. In order to make current flow of diode more clear, effects of connecting diode with battery by first and second method respectively is explained with the help of figure given below.
Source:
The Diode block is simulated by a resistor, an inductor, and a DC voltage source connected in series with a switch. The switch operation is controlled by the voltage Vak and the current Iak.
Source:
The diode that was on the bike probably had only 3 connections but the RS diode has 4. Where does the extra wire go? The bike's original unit had a 4th connection but you didn't notice it because it was on the mounting lug, the ground. As you look at the diode, 2 of the wires are marked AC. Connect one of the 2 stator wires to each of the AC posts. That will leave a "plus" and a "minus" lug. If the bike is a positive ground like a triumph, connect the "minus" lug to the battery wire (it originally went to the center lug of the Lucas diode).
Source:
When the voltage on the anode is higher than on the cathode then current flows through the diode (the resistance is very low). When the voltage is lower on the anode than on the cathode then the current does not flow (the resistance is very high).
Source:
MORE ABOUT
Diode