LYCOS RETRIEVER 
Capacitor: Frequencies
built 632 days ago
Test searching results for the resonance conditions of a typical chip aluminum electrolytic capacitor are presented as a reference below. These results show the forces subjected to the capacitor. The test conditions were a sweep frequency range between 10 and 2000 Hz, which spanned 7.5 minutes. Graph 1 shows the test results when the vibration was applied in the direction shown in Figure 1, anticipating broken leads in the chip aluminum electrolytic capacitor as the failure mode in the vibration test.
Source:
A capacitor is often used to store analogue signals and digital data. Another type of capacitor is used in the telecommunications equipment industry. This type of capacitor is able to adjust the frequency and tuning of telecommunications equipment and is often referred to a variable capacitor. A capacitor is ... ideal for storing an electron. A capacitor cannot, however, make electrons.
Source:
The frequency of the capacitor transient is equal to the system’s natural frequency. Therefore, large capacitor banks will result in lower frequency decaying ring wave transients, while small banks will result in higher frequency ring wave transients.
Source:
MORE ABOUT
Frequencies